Input please.
Replacing all running gear/lines on my Triton for cruising.
I have no idea how old my lines are, or can’t even tell for sure what kind it is. The toping lift already failed dropping the boom inches from my wife.
I will not have any cable on the mast just line (can’t stand all the noise)
Any recommendations or input would be appreciated.
Antonio
Appropriate and recommended size for running gear
-
- Bottom Paint Application Technician
- Posts: 23
- Joined: Tue Feb 03, 2009 12:39 pm
- Location: North West Florida
Appropriate and recommended size for running gear
Nossa Senhora da Conceicao
Pearson Triton 1961 Hull #195 (Formerly Winsome)
Pearson Triton 1961 Hull #195 (Formerly Winsome)
- Tim
- Shipwright Extraordinaire
- Posts: 5708
- Joined: Tue Apr 01, 2003 6:39 pm
- Boat Name: Glissando
- Boat Type: Pearson Triton
- Location: Whitefield, ME
- Contact:
Re: Appropriate and recommended size for running gear
I use 3/8" Sta-Set for main and spinnaker halyards, and most control lines (mainsheet, reefing lines). My genoa halyard is 3/8" Sta-Set X for slightly less stretch, since the sail's on a furler and less likely to have the halyard adjusted frequently. I use 7/16" Sta-Set for genoa sheets for comfort factors alone--the larger line is easier on the hand than 3/8", which would be adequate strength-wise.
If you want high-tech stuff, there's lots available, but Sta-Set is good, basic line that does the job without breaking the bank. You can actually go smaller diameter with some of the fancy stuff, but it gets too hard on the hands at anything below 3/8". The topping lift is a good place for a smaller, higher-tech, stronger line, if you want something different, and to minimize the size of the line flopping around up there. (I have a rigid vang and don't use a topping lift so can't give my own specification for that particular line.)
If you want high-tech stuff, there's lots available, but Sta-Set is good, basic line that does the job without breaking the bank. You can actually go smaller diameter with some of the fancy stuff, but it gets too hard on the hands at anything below 3/8". The topping lift is a good place for a smaller, higher-tech, stronger line, if you want something different, and to minimize the size of the line flopping around up there. (I have a rigid vang and don't use a topping lift so can't give my own specification for that particular line.)
---------------------------------------------------
Forum Founder--No Longer Participating
Forum Founder--No Longer Participating