Page 1 of 1
Prop size?
Posted: Fri Aug 30, 2013 2:27 pm
by Jeff PT403
I'm putting a Yanmar 2GMF in my Triton what would be the correct 2-blade prop to use?
Thanks
Jeff
Re: Prop size?
Posted: Fri Aug 30, 2013 11:08 pm
by earlylight
Jeff,
Michigan props website (
http://www.miwheel.com/) should provide the info you need. Good luck!
Re: Prop size?
Posted: Wed Sep 04, 2013 11:16 am
by Figment
I'm going to hazard a guess that the 2-blade prop necessary to put that much power into the water is going to be larger than you can comfortably fit in a Triton's aperture.
Re: Prop size?
Posted: Fri Sep 06, 2013 3:47 pm
by Jeff PT403
I was thinking a 14 x 12 in a 2 blade, Do you think I would be better off with a 3 ?
Jeff
Re: Prop size?
Posted: Fri Sep 06, 2013 6:50 pm
by earlylight
The MINIMUM vertical clearance between the tip of the propeller blade to the hull or prop aperture should be 15% if the prop diameter.
Re: Prop size?
Posted: Mon Sep 09, 2013 4:45 pm
by Figment
I know of 5 diesel powered tritons off the top of my head. They all run 3-blade wheels.
Re: Prop size?
Posted: Mon Sep 09, 2013 7:03 pm
by earlylight
The two Tritons I know of that have been re-powered with diesels also used 3 blade props. The aperture on a Triton is quite small.
Re: Prop size?
Posted: Tue Sep 10, 2013 5:40 am
by TritonSean
Just repowered this year. Had to have a new prop made. It was a 12x9 right hand three blade. the old prop was a larger three blade.
I think you need three blades. Lots of fun prop walk in reverse !
Sean
Re: Prop size?
Posted: Fri Sep 13, 2013 1:10 pm
by Jeff PT403
So 12x9 three blade is the consensus?
Thanks Jeff
Re: Prop size?
Posted: Sun Sep 15, 2013 4:48 pm
by barrybrown
Jeff
I have re-powered two Tritons with diesel, one with a Perkins 3 cyl 18 hp and the other with a Vetus 2 cyl 13 hp. Each engine had 2.72 to 1 reduction gears. In each case I used Campbell 3 blade propellers on the Perkins it was 13 x 9.5 and on the Vetus it was 13 x 7.5.
Each engine had a max RPM of 3600 and in each case that was about the max I could achieve at full throttle.
Barry
Re: Prop size?
Posted: Mon Sep 16, 2013 5:31 am
by TritonSean
Jeff
that sounds about right. I get 3500 rpms before the stern sits right down. Definetly need a three blade prop.
Re: Prop size?
Posted: Fri Sep 27, 2013 10:22 am
by triton274
I didn't do the instal but when I had a triton it had a Yanmar 2gm20F with a 2 blade prop. I never had any issues with it.