Bending genoa T tracks
Posted: Tue Mar 16, 2010 2:42 pm
I need to replace a section of 1.25inch aluminum T-track that is curved to conform to the deck edge. How easy is it to bend T-track of this size? Any tips?
https://www.plasticclassicforum.com/forum/
https://www.plasticclassicforum.com/forum/viewtopic.php?f=26&t=4840
When I was installing my rub rail i fabricated a U shaped jig and some wedges to hold it in place while I drilled and screwed. On a few occasions it would spring loose and wack me in the chest. Never knocked me off the staging but it left some impressive bruises.Really? Just spring it? I see myself being flung off the ladder as I tried to hold the track to a bend as I tried to drill the boltholes...pwuuunnng!